cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
622
Views
0
Helpful
3
Replies

DX650 No Display

haris_qazi
Level 1
Level 1

Hi,

I am facing issue with a new DX650 Phone. When I connect the PoE power the Phone does not boot and it doesn't show anything on the display.

Attached snapshot of the DX650.

Thanks.

BR

Haris Shuja

3 Replies 3

islam.kamal
Level 10
Level 10

Hello

Check POE switch

1- Can you connect one of your Cisco IP phones which work well with same port which you use for DX650.

 

Check UTP cable

1-Check to replace the cable with new one

 

Check switch logs

2- Kindly check logs after you plug your Cisco IP phone  to check the power . use the below

switch(conf)#logging console  " if you logging as console".

or

switch#terminal monitor  " if you logging as telnet or ssh"

 

Thanks

please rate all useful information

 

Thank you for your response.

- I have other DX650 which are working perfectly on the same switch and port.

- Already used multiple cables.

- The DX650 isn't powering on properly.

- When I do show cdp neighbor, it is not being discovered.

- When I do show power inline it is taking 15.4 W when it actually should take 13.7.

- There are no messages on Console except for port up / down and poe.

 

Thanks.

Hi

last test , if you have external charger try to connect it to your IP Phone?. If you still have the problem , you have to do RMA for this IP phone back to cisco to replace it with new one.

 

 

Thanks 

please rate all useful information

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: