Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dynamic Cluster Config Enable

Does someone knows what "Dynamic Cluster Config" parameters is about on CUCM?

Everyone's tags (1)
8 REPLIES
Cisco Employee

Where do you see this

Where do you see this parameter?

Manish

New Member

On the Cisco Unified

On the Cisco Unified Communications Answer File Generator

 

http://www.cisco.com/web/cuc_afg/index.html

 

Alex

Cisco Employee

Hi Alex,There isn't any

Hi Alex,

There isn't any proper documentation available for this parameter, however as per one of the internal links that i could access it refers to auto registration.

HTH

Manish

 

New Member

HI ManishInteresting. What

HI Manish

Interesting. What auto-registration is referring to?

Thanks

Alex

Cisco Employee

Hi Alex,Please check the

Hi Alex,

Please check the following link

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/7_1_2/ccmcfg/bccm-712-cm/b02autor.html

HTH

Manish

New Member

Hi ManishI do know about

Hi Manish

I do know about phone auto registration but that usually set AFTER you install the server on the GUI interface and installation parameters does not affect ip telephone dial plan/registration parameters. Also, to set autoregistration you have to do more than enabling it, you have to configure the extension range for example.

I suspect this is something different related to CUCM node creation inside de cluster (node registration). Node registration needs to be done manually on the publisher. Could you find out more, please?

 

-Alex

 

 

 

 

Cisco Employee

Hi Alex,Even i am not fully

Hi Alex,

Even i am not fully convinced due to lack of any information in any of the forums or database about this parameter. However, i further looked into the sub-parameters under Dynamic-Cluster-Configuration and checked the info about 'Dynamic Cluster Config Timer which is described as - "This field gives information of the timer value set for auto registration post-install. i.e. this sets the widow by which auto registration needs to be done. Otherwise it defaults to the existing way of adding servers to the server table." So, this seems to be referring to server table entries on the Pub.

If you need any further clarity on this, a TAC case would be a good option.

HTH

Manish

New Member

Hi Manish Thank you.

Hi Manish

 

Thank you.

329
Views
0
Helpful
8
Replies