12-20-2011 12:41 AM - edited 03-16-2019 08:37 AM
Hi everyone!
I need 2 E&M cards in my 3945 ISRG2.
Scenario:
NM-HD-2V network module with two slots + 2x E&M interface cards (VIC3-2E/M).
I already have one PVDM3-128 in my 3945 router.
Question:
Will this module use the same PVDM, which is present in a router, or I need to buy an additional PVDM and plug it into
NM-HD-2V network module to support these E&M cards?
DSP calculator tells me that I don't need no additional PVDMs, but i'm not sure about it.
Regards,
Aleksei
12-20-2011 12:45 AM
You can install the E&M VICs in the WVIC slots, no need for NM.
12-20-2011 12:47 AM
Problem is that I'm out of WVIC slots, thus I need NM.
12-20-2011 05:56 AM
Then use it.
12-20-2011 05:59 AM
That's what I want.
Question was:
Will this module use the same PVDM, which is present in a router, or I need to buy an additional PVDM and plug it into
NM-HD-2V network module to support these E&M cards?
12-20-2011 06:18 AM
Hi,
From link
Note For the NM-HD-1V, NM-HD-2V, and NM-DS-2VE network modules, DSPs are on-board and are not field-replaceable units (FRUs).
Therefore this unit provides DSPs for you.
HTH
Alex
12-20-2011 06:22 AM
Thank You,
Now it makes sence
Regards,
Aleksei
12-20-2011 06:35 AM
Aleski,
The NM-HD-2V only has enough DSP resource for :-
HTH
Alex
Please rate useful posts
12-20-2011 06:53 AM
acampbell wrote:
Hi,
From link
Note For the NM-HD-1V, NM-HD-2V, and NM-DS-2VE network modules, DSPs are on-board and are not field-replaceable units (FRUs).
Therefore this unit provides DSPs for you.
HTH
Alex
I think that in this sentence cisco wanted to tell NM-HD-2VE, not NM-DS-2VE. Even in google I didn't found
NM-DS-2VE module.
Aleksei
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: