Hi All, I managed to establish E1 CAS connection between Cisco 2800 series router & a 3th party TDM IVR. With the following commands,
controller E1 0/1/0 framing NO-CRC4 clock source line primary ds0-group 1 timeslots 1 type fxo-loop-start ds0-group 2 timeslots 2 type fxo-loop-start
And tried to do the same thing with a AS5400 XM but unfortunatelly “fxo-loop-start” is not supported in AS 5400XM
(config-controller)#ds0-group 0 timeslots 1 type ? e&m-fgb E & M Type II FGB e&m-fgd E & M Type II FGD e&m-immediate-start E & M Immediate Start fxs-ground-start FXS Ground Start fxs-loop-start FXS Loop Start none Null Signalling for External Call Control p7 P7 Switch r2-analog R2 ITU Q411 r2-digital R2 ITU Q421 r2-lsv181-digital R2 LSV 181 r2-pulse R2 ITU Supplement 7 sas-ground-start SAS Ground Start sas-loop-start SAS Loop Start
Which one should i use instead of “ fxo-loop-start “
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...