I have 2 routers connnected nack to back using t1 crossover cable, when i configure e1 with r2-digital r2-compelled signalling with the first 3 channels(timeslots 1-3), on both ends the channels come up in blocked state???
No timing or frame or line coding issue as i can configure the port as pri and it works great!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.