I have a new 3825 running c3825-ipvoicek9-mz.124-4.XC4.bin as recommended by cisco for using 7931 phones, I have a VWIC2-1MFT-G703 card installed, "1 Channelized (E1 or T1)/PRI port" shows up in the "show ver" command, however there is no controller in the config, also i am unable to configure isdn switch-type, commands for controller and isdn switch type are unrecognised, any ideas anyone ?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.