Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 flap

My all outgoing calls sometimes come down after less than 1 minute.

I think that the reason of this issue is due to that E1 flap.

I made debug for the E1 and the results are attached.

So, if you please, if any one suggest what is the real reason and if it is from my router side or from the C.O. side.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: E1 flap

Keep monitoring and please remember to rate useful posts with the scrollbox below.

7 REPLIES
Hall of Fame Super Gold

Re: E1 flap

Send "show controllers E1". Do not enable any other debugs.

New Member

Re: E1 flap

Please, find attached sh controller e1 as per your request

Hall of Fame Super Gold

Re: E1 flap

Configure:

network-clock-select 1 e1 0/1/0

Then check again you must have 0 errors, 0 slips.

New Member

Re: E1 flap

sorry, where can i find 0 errors, 0 slips.

Anf if so achieved, the line will not flap again

Hall of Fame Super Gold

Re: E1 flap

You must enter the command above first, then check later.

New Member

Re: E1 flap

Thx a lot as i entered the command, and no error now.

But, now E1 will not flap again.

Hall of Fame Super Gold

Re: E1 flap

Keep monitoring and please remember to rate useful posts with the scrollbox below.

253
Views
0
Helpful
7
Replies