01-04-2010 04:08 AM - edited 03-18-2019 10:58 AM
Hi,
I have CME in one of our office location with SIP based Connection over internet with a E1 output ( SIP GW box ) to the Cisco router.
The SIP provider is asking me to configure the Cisco E1 card in TE mode, How do i configure that.
Please help!
Arif
01-04-2010 10:03 AM
controller e1 ..
clock source internal
int serial x/x/x:15
isdn protocol-emulate network
That's it.
01-04-2010 10:30 PM
Hi ,
Thanks for the reply,
I have peculier problem after the changes , like when i make a out going call I am not able to hear the ringing sound , I will hear the voice only after
the calls is answered by the remote end.
The incoming calls works fine.
What do you think could be problem ?
Arif
01-05-2010 03:54 AM
Send "debug isds q931" and "term mon".
Please remember to rate useful posts clicking the stars below.
01-05-2010 04:20 AM
Under the POTS dialpeer add the following:
progress_ind alert enable 8
01-05-2010 05:38 AM
01-05-2010 05:55 AM
You are sending out the same incoming call.
You must configure so that 932417563 rings somewhere, an ephone-dn or what you want.
Please remember to rate useful posts with the scrollbox below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: