Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 PRI - R2 config help needed!

Hi all,

Can someone please post a typical or suggested current/known working configuration of an E1 "PRI" with R2 signaling for incoming voice (DID) + outbound PSTN

I have 10 channels available from the Provider (TELMEX) in Mexico so not sure if and where I need to configure a D-channel ?

I am used to only using US based 23B+1D configurations so any help with this R2 Mexico E1 would be great

Im using a 2921 ISR with a VWIC3-2MFT-T1/E1 card and a PVDM3-32 DSP running CME 8.6

We only have a small 1 hour window tomorrow AM to test - I'm moving the E1 from a production Mitel system to my 2921 CME To test before we permanently migrate/cut over to the CME in a few days -

so this is my only chance to get the new Cisco configured and ready with a live E1 before the cut! So really helps to have a verification/sanity check of what my config should be before I start testing, as to not waste my only window of opportunity with a live circuit)

THANKS so much in advance

MJ

Sent from Cisco Technical Support iPhone App

1 REPLY
Blue

E1 PRI - R2 config help needed!

HI

Following link shows you E1 R2 configration.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a00800ad389.shtml

or

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/246672r2.pdf

Regards

Ronak Patel

Rate helpful posts.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
656
Views
0
Helpful
1
Replies