Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 R2 between 2811 and Nortel 11C receiving dialed digits

Hi, i have a problem. When i make calls from Callmanager to PBX Nortel works. But calls from PBX Nortel to Callmanager there a delay a couple seconds then i hear dial tone ,i dial the number and works.Any idea?

PBX Nortel--E1R2---GW2811--Callmanager

PBX Nortel 11C rls 81

Gw2811 IOS c2800nm-spservicesk9-mz.124-3i

Callmanager 5.1.3

Regards

6 REPLIES

Re: E1 R2 between 2811 and Nortel 11C receiving dialed digits

Sounds like you need an inbound dial peer with "direct-inward-dial" such as:

dial-peer voice 1 pots

incoming called-number .

direct-inward-dial

Hope this helps.

Brandon

New Member

Re: E1 R2 between 2811 and Nortel 11C receiving dialed digits

Hi Brandon, but the problem still continue.

Regards

New Member

Re: E1 R2 between 2811 and Nortel 11C receiving dialed digits

Hi ...pls need help.

The debug is attch.

Hall of Fame Super Gold

Re: E1 R2 between 2811 and Nortel 11C receiving dialed digits

As Brandon said, this is caused by need of direct-inward-dial. may be you have another pots DP being matched before DP 1, need to check config.

Re: E1 R2 between 2811 and Nortel 11C receiving dialed digits

Run "debug voip dialpeer" and see what dial peer is being matched.

Brandon

New Member

Re: E1 R2 between 2811 and Nortel 11C receiving dialed digits

Dear Brandon

Now is working. I saw in the debug voip dialpeer that the PBX send a five digit. I put a num-exp and all works.

Thanks a lot!

237
Views
0
Helpful
6
Replies