E1 R2 between 2811 and Nortel 11C receiving dialed digits

[cristian.munoz]

Hi, i have a problem. When i make calls from Callmanager to PBX Nortel works. But calls from PBX Nortel to Callmanager there a delay a couple seconds then i hear dial tone ,i dial the number and works.Any idea?

PBX Nortel--E1R2---GW2811--Callmanager

PBX Nortel 11C rls 81

Gw2811 IOS c2800nm-spservicesk9-mz.124-3i

Callmanager 5.1.3

Regards

[Brandon Buffin]

Sounds like you need an inbound dial peer with "direct-inward-dial" such as:

dial-peer voice 1 pots

incoming called-number .

direct-inward-dial

Hope this helps.

Brandon

[cristian.munoz]

Hi Brandon, but the problem still continue.

Regards

[cristian.munoz]

Hi ...pls need help.

The debug is attch.

[paolo bevilacqua]

As Brandon said, this is caused by need of direct-inward-dial. may be you have another pots DP being matched before DP 1, need to check config.

[Brandon Buffin]

Run "debug voip dialpeer" and see what dial peer is being matched.

Brandon

[cristian.munoz]

Dear Brandon

Now is working. I saw in the debug voip dialpeer that the PBX send a five digit. I put a num-exp and all works.

Thanks a lot!