Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 R2 configuration

We need to deploy Cisco IPT in Manila. But they're using E1 R2 for DID (incoming) trunks and analog CO for outgoing trunks. Can anyone share the vg configuration as we know this vg should be h323 config? Would you please also suggest which IOS is better work for E1 R2? The vg we use is C2851 and our CCM is 4.1(3) SR3a.

4 REPLIES
Hall of Fame Super Gold

Re: E1 R2 configuration

Hi,

yes, you must use H.323 or SIP for E1 R2.

I suggest you use 12.4(3j) for the router.

The R2 support has knowledge of the Phillipines:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1830/products_feature_guide09186a00800873eb.html

But all further customization must be done in-site.

Good luck!

New Member

Re: E1 R2 configuration

Here is a example of my E1 R2 setup from Mx using a 3825 in H323 hope this helps

you will not be needing the Telmex

controller E1 0/0/0

framing NO-CRC4

ds0-group 1 timeslots 1-15,17-30 type r2-digital r2-compelled ani

cas-custom 1

country telmex

category 2

answer-signal group-b 1

caller-digits 10

ani-digits min 0 max 12

description E1-Phones-Villahermosa

New Member

Re: E1 R2 configuration

Thanks. The exsiting E1 R2 DID is subscribed from PLDT of Manlia. Is there exact configuration sample in vg?

Besides, is there any special configuration in CCM admin?

Hall of Fame Super Gold

Re: E1 R2 configuration

Hi,

each and any E1 R2 configuration is different. Because of this I said above, you need to find the exact parameters once in place.

352
Views
0
Helpful
4
Replies