This E1 is generating a lot of Line Code Errors and Path Code Errors.
When i make an loop on this E1 i dont have any errors.
We have another router with other E1 R2 from another Telco, if i switch the E1s, the first E1 is generating errors on the other router.
We put a new a router a e1 module and cable and not solves the issue.
The Telco says that its ok.
I try to change the line code to AMI but the E1 dont come up, follow the config:
controller E1 0/2/0 framing NO-CRC4 line-termination 75-ohm ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani cas-custom 0 country brazil metering answer-signal group-b 1 dnis-digits min 1 max 4
I think the problem is not on our side.
We can send and receive calls in this e1 but the call are dropping when the E1 is increasing the errors
What debug can i see the Telco disconnecting the call?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...