ds0-group 1 timeslots 1-15,17-31 type r2-digital r2-compelled ani
country telmex use-defaults
answer-signal group-b 1
where an outbound calling seems slow, i.e. 10 seconds before proceeding with the call, debug vpm shows about 150ms delay between each digit being passed, is there a way to speed this up? I realize this E1 CAS R2 is not expected to be as fast as PRI, but this seems quite slow. Any input is appreciated. Debug output:
At the bottom of the page it states the following:-
There are three types of interregister signaling:
R2-Compelled—When a tone-pair is sent from the switch (forward signal), the tones stay on until the remote end responds (sends an ACK) with a pair of tones that signals the switch to turn off the tones. The tones are compelled to stay on until they are turned off.
R2-Non-Compelled —The tone-pairs are sent (forward signal) as pulses so they stay on for a short duration. Responses (backward signals) to the switch (Group B) are sent as pulses. There are no Group A signals in non-compelled interregister signaling.
Note: Most installations use the non-compelled type of interregister signaling.
R2-Semi-Compelled—Forward tone-pairs are sent as compelled. Responses (backward signals) to the switch are sent as pulses. It is the same as compelled, except that the backward signals are pulsed instead of continuous.
Note: Do not use compelled signaling on slow (satellite) links. The call setup time is too large because of distance delays.
Looking at your trace I see that the sizure to siezure ACK takes about 84mS
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.