Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 R2 with signaling on channel 0 and 15?

I am trying to bring up a voice circuit in Buenos Aeries. The provider is telling me they use signalling on channel 0 for 1-15 and siignaling on channel 16 for 17-31. How can I configure my 3845 router with VWIC-MFT-E1 to support this? Standard E1 R2 config with argentina country option does not seem to work.

2 REPLIES
Hall of Fame Super Gold

Re: E1 R2 with signaling on channel 0 and 15?

Hi, your provider may be is confusing the exact roles of channel 0 and 16, that is why he is saying that. I've found the following that references Argentina a bit.

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_serv/as5800/120t/5800_r2.htm

I understand that you may have seen it already and could not apply to your situation.

Good luck

Re: E1 R2 with signaling on channel 0 and 15?

I think what they want is two signalling groups, so you will have two ds0-groups defined under the same controller interface.

Check this link

http://www.cisco.com/en/US/products/sw/iosswrel/ps1830/products_feature_guide09186a00800873eb.html

273
Views
0
Helpful
2
Replies