Ok so I have troubleshooted E1 slips and errors multiple times before. I am aware that the issue is due to clocking. Heres my problem:
I have configured to take clocking from E1 1/0 which is a telco PRI and this is working fine on E1 1/0 i.e no slips, errors.
However on E1 1/1 and E1 2/0 which are 2 other PRI lines, there is slips and errors incrementing.
Configuration of E1 clocks:
network-clock-participate slot 1
network-clock-participate slot 2
network-clock-select 1 E1 1/0
network-clock-select 2 E1 1/1
network-clock-select 3 E1 2/0
Network Clock Configuration
---------------------------
Priority Clo
ck Source Clock State Clock Type
1 E1 1/0 GOOD E1
2 E1 1/1 GOOD E1
3 E1 2/0 GOOD E1
10 Backplane GOOD PLL
Anyone got any advise as to what I can do next? I have also tried to set the clock source as Internal on the E1 lines but same errors and slip increment. Is my only option to go to the Telco?