I'm a little confused about the status of support for E1 connections on IAD2431-1T1E1 devices. Nearly all the documentation I read for this device says that it has 2 T1/E1 ports. However when I read the release notes for IOS release 12.4 it states...
'One or two T1 ports for WAN connection or with channel-associated signaling (CAS) for connection to a digital PBX, except for the Cisco IAD2430-24FXS IAD, which supports none. E1 ports are currently not supported.'
What do they mean 'E1 ports are currently not supported'? Does this mean that the T1/E1 ports are just really T1 ports or can they really be used to connect to another E1 device?
FYI...we are wanting to implement a SIP gateway connecting to our existing IVR servers running Dialogic D/600JCT-1E1 E1 cards so any advice on a good device to do this would be appreciated.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.