Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 with MFC-R2

I would like to ask whether CCM 4.1(3) sr3a with vg support E1 MFC-R2 signalling by using MGCP controlled. If yes, how to configure?

5 REPLIES
Hall of Fame Super Gold

Re: E1 with MFC-R2

No, it does not.You will need H323 on the GW for E1-R2.

Hope this helps, please rate post if it does!

New Member

Re: E1 with MFC-R2

so, where can i get the configuration in h323 connection?

Hall of Fame Super Gold

Re: E1 with MFC-R2

Hi,

config for E1 R2 is very peculiar to country and telco. Where are you located ? In the forum there are posts with examples for telmex and few others. For an introductory discussion, see:

http://cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800942f2.shtml

Advice: if you have _any_ chance to have the circuit provision as PRI instead, do that. E1 R2 is very challenging to configure and troubleshoot if something goes wrong.

New Member

Re: E1 with MFC-R2

tks for support, the place we deploy is Manila. we try to ask them to change into E1 PRI, but i know that DDI range can't keep. so it is difficult.

besides, is it possible that mgcp can support it in later ccm version, say 6.0?

Hall of Fame Super Gold

Re: E1 with MFC-R2

hi,

CCM 6.0 is out and doesn't support E1 R2. I think the reason is that it is so complicated, that only the router can do it.

1164
Views
3
Helpful
5
Replies