Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EM problem after migration to CCM 5.0

Hi,

I had a 4.1(3) cluster working so good. I created a demo environment and did the migration to 5.0 throught DMA, etc.

After I have migrated the CCM to 5.0, I have two problems:

1 - EM doesn't work through button Service in my 7940. I got the message Host not Found. When I configure EM URL in the Speed Dial of 7940, it works fine. The 7912 and IPC works fine too.

2 - I got the new firmwares to 7940 and I have installed in CCM 5.0. I have configured device default with the new firmware but the 7940 doesn't launch the upgrade. Why?

Can anyone help me?

tks

1 REPLY
Silver

Re: EM problem after migration to CCM 5.0

Perform the following:

1) Check the URL in the services page

2) Checkthe device association

3) Restart the tomcat and IIS Administation service

93
Views
0
Helpful
1
Replies