I have an issue in a site in Austria that is related to isdn overlap. I recently migrated this site from a PBX to CUCM v9.1. Just recently i found out that some callers to the facility were not getting through, which was related to isdn overlap-receiving. That issue is now resolved, however there is one number (the site prefix) that should be redirected to reception when it is called.
Site prefix - +43166105 followed by 4 digits
When i call the +43166105 number it shows up on my gateway with no DNIS information and is waiting for extra digits as per the ISDN overlap requirement. The requirement is that if no digits are entered it should redirect to reception but i cannot get it to work without breaking the overlap receiving config. Presently if digits are entered they are expanded to e.164 and sent to CUCM.
What i have tried aleady is add the following incoming DP on the expectation that the DP would be matched on ANI as Destination pattern, and null DNIS would be translated to the reception number, this piece of configuration worked but had the unexpected side effect of breaking the overlap recieving configuration
dial-peer voice 98 pots trunkgroup A1_Telekom translation-profile incoming INBOUND service session destination-pattern . fax rate disable forward-digits all
voice translation-rule 1 rule 3 /^$/ /+431661050/
Here is my configuration as it stands, everything works except +43166105 , presently to reach reception a caller can enter '0' after dialing the +43166105 prefix
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...