Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Enable outbound caller-id individually

I have outbound caller id blocked for the entire organization and I wondered if it was possible to enable it for one individual user.

thanks

5 REPLIES
Cisco Employee

Re: Enable outbound caller-id individually

where do you have it blocked???? you don't say that

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Enable outbound caller-id individually

Route pattern

Calling line id presentation: restricted

Calling name presentation: restricted

Can i block it elsewhere instead that would allow me to accomplish what i want?

Cisco Employee

Re: Enable outbound caller-id individually

easiest way would be to configure a route pattern 9.@ and that only that particular user could reach it

otherwise you would need to create a copy of each route pattern and have it on a partition that only that user can use

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Enable outbound caller-id individually

If you are not using any " calling party mask" at the route pattern or route list , you can apply a fake " External mask" at the device level for the devices whose caller id you want to block.

Check " use calling party mask" at the route pattern .

New Member

Re: Enable outbound caller-id individually

Thanks for the ideas, I'll try them out and see what works best for us.

Thanks

185
Views
10
Helpful
5
Replies
CreatePlease to create content