End Call button does not always show when on a call and another call come in
End user is reporting "End Call button does not always show when on a call and another call come in. The customer would like to hang up on line 1, but the End Call button does not show when another call is ringing in"
I don't see End Call as a option under Softkey Template for Ring In?
End Call button does not always show when on a call and another
Try changing the System setting Auto-Call Select. With this Enabled the Display Focus (and Softkeys) always switch to the new incoming call. So if disabled the focus and Softkeys will stay on Call #1 so the End Call softkey
can be selcted.
Available on an individual phone via this setting
Device>Phone>Phone Configuration>Product Specific Configuration>Auto Call Select>Disabled
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.