I'm using CUCM 6 and have setup a test voice gateway. I am using MGCP to control the gateway. The call manager reports the E1 endpoint registration status as unknown yet I can make calls out via the E1 PRI.
Here is a shown ISDN status
test-mgcp-rtr#show isdn status
Global ISDN Switchtype = primary-net5
%Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. Layer 3 output may not appl
Re: Endpoint showing unknown for registration status
You may need to restart the Realtime Information Service (RIS) to clear up the discrepancy, and sometimes restarting the TFTP service helps as the TFTP service the gateway is using to auto-configure has gotten stuck and cannot complete.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...