I have a 7960 phone that will not register. There is no ephone in the configuration with that MAC however when I issue a sh ephone CLI, the MAC is listed as below. Note the lack of a primary_dn. The IP listed does not reply. Is there a way to force remove or clear a stuck ephone registration (without rebooting the CME)?
telephony-service sdspfarm units 4 no auto-reg-ephone max-ephones 65 max-dn 65 ip source-address 172.XX.XX.XX port 2000 max-redirect 5 system message BHFS Phoenix url services http://172.XX.XX.XX/voiceview/common/login.do url authentication http://172.XX.XX.XX/CCMCIP/authenticate.asp cnf-file location flash: load 7915-12 B015-1-0-4.SBN load 7915-24 B015-1-0-4.SBN load 7937 apps37sccp.1-4-3-0.bin load 7962 SCCP42.9-1-1SR1S.loads load 7975 apps75.9-1-1TH1-16.sbn load 6921 SCCP69xx.9-1-1-0.loads time-zone 7 voicemail 4050 max-conferences 8 gain -6 moh "flash:silence.wav" multicast moh 220.127.116.11 port 2000 route 172.XX.XX.XX web admin system name xxxxx secret 5 dn-webedit time-webedit transfer-system full-consult dss transfer-pattern .T secondary-dialtone 9 directory entry 1 4151 name BHFS-Phoenix create cnf-files version-stamp 7960 Apr 29 2012 13:42:01
The show run | s ephone isn't going to show you anything because there is no ephone 43 in the config (running or start) hence my confusion of why the not working ephone shows up in a show ephone ( and as resistered no less)
ephone sum det shows the same entry as I listed above
I did not try the dummy MAC. I ended up just using that ephone and mapping the ephone-DN (out of sequence but the system has 6 months before it is replaced).
I think the actual question I had was 'Is there a CLI in the CME router (IOS 15.2(3)T - Telephony 8.8) that allow me to clear a SCCP registration like I can with a SIP registration. (At least I recall doing that at one point). With our affecting all other phones'
I knew what the issue was / is, just don't know if it is possible to clear without a reboot.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.