06-10-2014 12:36 AM - edited 03-16-2019 11:03 PM
Hello everybody.
I have two different infraestructures in my telephony network.
One Cisco, with one publisher, a suscriber and two voice gateways, one of them connected with a Nortel CS-1000 PBX by a QSIG.
When I try to do a conference between a Cisco and a Nortel, the Nortel phone leaves the conference itself.
Between Cisco phones, there is no problem.
Can anybody help me?.
Thanks in advance
06-10-2014 01:14 AM
How do you integrated Cisco with Nortel ? Which protocol ?
Does the Trunk/GW between Cisco and Nortel contains CFB in its MRGL ? Which all codec are in use when you do conference ?
If there is mismatch in codec then you need Xcoder for this.
06-10-2014 02:44 AM
Hello!
'one of them connected with a Nortel CS-1000 PBX by a QSIG..'using E1/T1? If yes, try to use 'debug isdn q931' to see, who sends release message. If it goes from CUCM, then go through steps that Manish has suggested.
Regards,
Kirill
06-10-2014 12:24 PM
Attach CallManager traces for one of these calls.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: