Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Error doing conferences between Cisco and Nortel phones

Hello everybody.

I have two different infraestructures in my telephony network.

One Cisco, with one publisher, a suscriber and two voice gateways, one of them connected with a Nortel CS-1000 PBX by a QSIG.

When I try to do a conference between a Cisco and a Nortel, the Nortel phone leaves the conference itself.

Between Cisco phones, there is no problem.

Can anybody help me?.

Thanks in advance

3 REPLIES

How do you integrated Cisco

How do you integrated Cisco with Nortel ? Which protocol ?

Does the Trunk/GW between Cisco and Nortel contains CFB in its MRGL ? Which all codec are in use when you do conference ?

If there is mismatch in codec then you need Xcoder for this.

Cisco Employee

Hello!'one of them connected

Hello!

'one of them connected with a Nortel CS-1000 PBX by a QSIG..'using E1/T1? If yes, try to use 'debug isdn q931' to see, who sends release message. If it goes from CUCM, then go through steps that Manish has suggested.

Regards,

Kirill

 

Attach CallManager traces for

Attach CallManager traces for one of these calls.

76
Views
0
Helpful
3
Replies
CreatePlease login to create content