cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
414
Views
0
Helpful
2
Replies

Error in login to CME

i have CME and i can't telnet it or access GUI interface and i get the attached error .

2 Replies 2

Darren Preuss
Level 1
Level 1

Hello Gharip,

Can i just ask if you have the following in your configuration:

Router> enable

Router> config terminal

Router(config)#

Create a user account with privilege level 15.

Router(config)# username name privilege 15 secret 0 password

Ensure that you have a correctly configured interface whether it be a 802.1q interface or similar or a directly accesible ethernet port

Router(config)# int FastEthernet0

Router(config-if)# ip address 192.168.1.1 255.255.255.0

Router(config-if)# no shutdown

Router(config-if)# exit

Configure the router as a http server

Router(config)# ip http server

Configure the router for local authentication

Router(config)# ip http authentication local

Configure the VTY lines for privilege level 15 (this effectively allows access to Priv exec mode.

Router(config)# line vty 0 4

Router(config-line)# privilege level 15

Router(config-line)# login local

Router(config-line)# exit

I am guessing by your screenshot that your HTTP path is correctly configured. If not set it to the GUI directory which my be HTTP path flash:/gui

I hope this helps some.

Good luck

Daz

CCNA, CCNA (Voice),

islam.kamal
Level 10
Level 10

Hi Gharip

Please find the below:-

1- Make sure that you have GUI files on your flash:-

2-Please find the below commands:-

ip http server

ip http path flash:/gui

or

ip http path flash:

2-Under Telephony-service you have to set username and  password

telephony-service

web admin system name cisco123 password cisco123

Thank you

Please rate all useful infromation

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: