Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

EVM-HD-8FXS/DID install issue

We have a customer with 2 EVM-HD-8FXS/DID modules.

When they install either of them into a 2851 router, the card is not recognised.

Is there any config required to see the card (like with an E1 card), or is it dependent on the slot on the router.

thanks

Colin

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: EVM-HD-8FXS/DID install issue

My understanding is that ISR G2 requires EM3-HDA-8FXS/DID, while the 28xx / 38xx requires EM-HDA-8FXS/DID.

5 REPLIES
Hall of Fame Super Red

Re: EVM-HD-8FXS/DID install issue

Hi Colin,

If the module is not recognised the likely culprit

is a lack of DSP resources    via PVDM2s.

Cheers!

Rob

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan
New Member

Re: EVM-HD-8FXS/DID install issue

He has an EVM-HD-8FXS/DID card with 2 x EM3-HDA-8FXS/DID expansion modules.
If he uses the older type of module (EM-HDA-8FXS) then it is OK.

Would the EM3-HDA-8FXS/DID modules require the use of a DSP3 ?

Hall of Fame Super Gold

Re: EVM-HD-8FXS/DID install issue

My understanding is that ISR G2 requires EM3-HDA-8FXS/DID, while the 28xx / 38xx requires EM-HDA-8FXS/DID.

New Member

Re: EVM-HD-8FXS/DID install issue

Are the EM-HDA-8FXS/DID modules still available

Hall of Fame Super Gold

Re: EVM-HD-8FXS/DID install issue

Yes they are.

648
Views
8
Helpful
5
Replies
This widget could not be displayed.