Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ExcessiveDAfaults in CCM

We are getting ExcessiveDAfaults in call manager 5.1 from the ops manager. Has anybody come across these ?

3 REPLIES

Re: ExcessiveDAfaults in CCM

I came across a lot of stuff around OM.. :-)

In this case you and I run into the same bug (if you run a HP server too).

This is the "regular" explanation...

ExcessiveDAfaults

http://www.cisco.com/en/US/docs/net_mgmt/cisco_unified_operations_manager/2.0/user/guide/Events.html

Description: The number of drive array faults has exceeded a threshold on a Compaq system running a Cisco Unified Communications application.

Trigger: Exceeded Drive Array Faults Threshold.

Severity: Critical.

Device Type: Media Server.

Event Code: 2100.

...and this is the bug

CSCsm60769

Bug Details

bus fault monitoring leads to False ExcessiveDAFaults Events

Symptom

Cisco Unified Operations Manager reports ExcessiveDAFaults Event

Condition

This has been observed when monitoring HP servers.

Workaround

The Event should be ignored when all drives in the server being monitored are reporting the same number of bus faults.

The issue is reproducible with the use of diags, aducli, and the P400.

It's in OM 2.0.1 and in 2.0.2...

Good luck,

Martin

Re: ExcessiveDAfaults in CCM

Maybe this helps you too. This are the issues I ran into:

- if you use DNS, node-to-node test does not work anymore (SW fix available from TAC)

- if you use only one interface on a server you cannot put the unused one to unmanaged (SW fix available from TAC)

- if you are on terminal server session on OM you cannot do a "csv" export. Enter this into Windows registry:

[HKEY_CLASSES_ROOT\.csv]

@="txtfile"

"Content Type"="text/plain"

"PreceivedType"="text"

- End-to-end calls (synthetic test) stops working after some time

And something to be aware of:

ATA-186 is not supported

C3560-8 switch is not yet supported

If you have ATA-186, configure both ports or you will have "tftp exceed" errors..

What's your overall experience with OM?

Cheers,

Martin

New Member

Re: ExcessiveDAfaults in CCM

Had the same issues with OM and HP Servers.

Result was: either increase the threshold or even better: replace the drive. There is a reason, when this error on a single drive appears. After I changed the affected drive, it went away. Do not expect any visual indicator from the drive or infos during boot.

Danny

362
Views
9
Helpful
3
Replies
CreatePlease login to create content