I have a CCM 4.X in my office and I?m having issue with the expansion module. The module (just 1) is attached to a CP-7960 Phone. When I try to configure speed dial numbers and Label on the expansion module, it accepts the numbers from the 7th button on the module even though I started assigning the numbers from the 1st button on the CMM speed dial interface. What could be the possible cause of this issue?
The phone is a 7960 IP Phone with 2 lines and 6 speed dials. I have already configured 20 speed dials. The 1st 6 numbers appeared on the 7960 phone, but instead of the 7th speed dial number to begin from the 1st button on the expansion module, it started from the 7th button leaving the 1st 6 speed dial buttons blank. I expect that the numbers onthe expansion module should begin from the first btton, or is there something I'm missing? Pls reply.
Although the Cisco Unified IP Phones 7960G and 7940G support similar features, each phone model can implement these features differently. Modify phone button templates to assign features to phone buttons and to customize features for a phone model.
Ideally, you modify templates before registering phones on the network. In this way, you can access customized phone button template options from Cisco Unified CallManager Administration during registration.
To modify a phone button template, choose Device > Device Settings> Phone Button Template from Cisco Unified CallManager Administration. To assign a phone button template to a phone, use the Phone Button template field in the Cisco Unified CallManager Administration Phone Configuration page. Refer to Cisco Unified CallManager Administration Guide and Cisco Unified CallManager System Guide for more information.
The number of buttons and features that you can customize varies based upon Cisco Unified IP Phone model. Familiarize yourself with the configuration options described in Table 5-2. "
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...