You would need to do some programming here if you wanted to actually force a logout at a specific time...
There is an extension mobility API that will do the job. Or CallManager AXL.
Be careful forcing mass logouts in very large sites. As it would lead to a mass login the next morning... there is a cap on how many logins are supported per hour.
Also, if you are running 4.X or 5.X then all your logins are dependant on the publisher being up. Single point of failure when everybody is logged out, could cause a slight headache in the morning! :)
It is pretty severe to log everyone out at a specific time.
If your boss is worried about security / toll fraud, I would suggest using time of day functionality to create some blocking that applies after hours. This is more flexible, then you can define certain extensions that this doesnt apply etc. Or even use FAC for making calls after hours - heaps of options.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...