Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

External Bell/Ringer on FXS Port and VoIP Phone w/ Call Mgr 8.6

Hello,

I am trying to make an external bell ring at the same time when a Cisco VoIP phone is called.  The environment we are in is very loud and the ringer was great before we implemented VoIP.

I have the external bell connected to a FXS port off of my 2800 router.  When I call the number I asssigned to it, it rings.  I assigned the same number to a Cisco VoIP phone in Call Manager, but it only rings if I have the "destination-number 9195551212" removed from the FXS port.

I searched for ideas/answers on the board, and found that some said to use the stcapp option and to set the maximum call option to 2 or higher on the number in call manager.  However, this made no difference; I can either have the bell ring, or the number - but not both.

Anyone have any ideas?

dial-peer voice 502 pots

description External Bell

preference 1

destination-pattern 9195551212*

incoming called-number .

port 0/1/2

!

*NOTE:  Number changed for example.

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

External Bell/Ringer on FXS Port and VoIP Phone w/ Call Mgr 8.6

Configure the port in SCCP mode, instead of H.323 as it is now  (search)

Register it to CUCM as analofport device.

Configure a shared line appearing on said device, and an IP phone.

The two will ring in parallel, done.

3 REPLIES
Hall of Fame Super Gold

External Bell/Ringer on FXS Port and VoIP Phone w/ Call Mgr 8.6

Configure the port in SCCP mode, instead of H.323 as it is now  (search)

Register it to CUCM as analofport device.

Configure a shared line appearing on said device, and an IP phone.

The two will ring in parallel, done.

New Member

External Bell/Ringer on FXS Port and VoIP Phone w/ Call Mgr 8.6

Hello Paolo,

What if this is a CUBE with DIDs traversing across the MPLS link.  Inbound DID hits dial-peer on the FXS port of the CUBE will take presents over the phone configured in UCM and never ring?  I believe Country is asking this question but could be wrong?  But if you know this answer it will help me with a similiar issue I am having.

Thx

Hall of Fame Super Gold

Re: External Bell/Ringer on FXS Port and VoIP Phone w/ Call Mgr

No, that is is a different question. Please open new thread for nww problems.

1575
Views
0
Helpful
3
Replies
CreatePlease login to create content