Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Extn mobility

With Extension mobiltiy, I have set the credentials so that users need to change the pin when they first log in. This works up to the point where you try and put the new pin in and it says Authentication error.

this is on CUCM 7.0 by the way

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Extn mobility

I dont think they can change their PIN via the IP Phone. It has to be done via the CCMUSER page.

Cisco Employee

Re: Extn mobility

Tommer is right, there is a very recent thread treating the same concern

IP Phone Services for End Users: Changing PIN from an IP phone in CUCM 6.1(3)

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Phone%20Services%20for%20End%20Users&topicID=.ee6c82d&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cd26d8f

on roadmap, so right now there is no way to do it directly on the phone.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
2 REPLIES

Re: Extn mobility

I dont think they can change their PIN via the IP Phone. It has to be done via the CCMUSER page.

Cisco Employee

Re: Extn mobility

Tommer is right, there is a very recent thread treating the same concern

IP Phone Services for End Users: Changing PIN from an IP phone in CUCM 6.1(3)

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Phone%20Services%20for%20End%20Users&topicID=.ee6c82d&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cd26d8f

on roadmap, so right now there is no way to do it directly on the phone.

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
128
Views
0
Helpful
2
Replies
CreatePlease to create content