cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
326
Views
3
Helpful
1
Replies

FAC Configuration

ricardorojas123
Level 1
Level 1

Hi,

I would like to configure the directory number in the Cisco IP Phone 7961 and CIPC, but I need than the calls from 7961 use FAC and the call from CIPC don´t use FAC.

That is possible?

Directory Number:    7000

Partition:         Internal   

Calling Search Space:     External

Route Pattern:

Pattern: 001613XXXXXX   

Partition: External

Require Forced Authorization Code: Enable

Calling Search Space: External

Selected Partition: Internal, External

Phone Type: 7961 (Phone configured with the DN 7000 PT Internal)

Note: The user enters the FAC.

Phone Type: CIPC (Phone configured with the DN 7000 PT Internal)

Note: The user does not enter the FAC

1 Reply 1

Leonardo Santana
Spotlight
Spotlight

If you enable the FAC on the route pattern all calls to this pattern will need FAC.

You can create another route pattern without FAC in other partition, create a new CSS and associate this CSS on the device page (CIPC).

Thanks

Rate this if helps you

Leonardo Santana

Regards
Leonardo Santana

*** Rate All Helpful Responses***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: