Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FAC for third-party SIP phone

I have a Call Manager 7.0 registered with Grandstream GXP 2010 SIP phones.

I have created a router pattern to use the FAC, but when a dial a number that uses the the route pattern with the FAC, there is no tone to enter the code.

Eventually the call fails.

Is there a way to make this work with third-party SIP phones with CM 7.0 ?

Or, is there a workaround to this scenario?

Thanks

WD

Project Engineer

2 REPLIES
Red

Re: FAC for third-party SIP phone

The following features are not supported on SIP phone:

  • CUVA  support
  • FAC/CMC support
  • MLPP target device
  • Direct  transfer
  • Hold tone

Michael

http://htluo.blogspot.com

New Member

Re: FAC for third-party SIP phone

Thanks for teh response.

I will need to figure out another way of making a restrictions to call by using a script like acctfixedpin.tcl.

584
Views
0
Helpful
2
Replies