Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

FAC not working with 3905

Hi

We have CUCM 9.1 with 3905 and 6921 phones, both phones are running SIP. 6921 working with FAC, but 3905 not working with FAC, when we enter FAC its not getting the PIN number,

Please guide to resolve this, is there any specific configuration for 3905 with FAC

Regds

$

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

FAC not working with 3905

5 REPLIES
Cisco Employee

FAC not working with 3905

Hi Fernando,

What is the firmware on 3905 and are you using variable length route patterns?

You could be running into the following

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCty26479

3905 unable dial to variable length route pattern with FAC

Symptom:

When dialing a variable length route patten such as 9011! or 900! the call is unable to be completed.

Conditions:

This will occur on a 3905 model phone if Forced Authorization Code is enabled on the route pattern.

Workaround:

Remove the requirement for Forced Authorization Code from the route pattern OR

Use  a non-variable length route pattern by adding a # to the route pattern,  such as 9011!# or 900!#.  Instruct users to dial a # after variable  length number.
The Predot-Trailing# digit discard instruction (DDI) should be used to avoid sending a # to the service provider

HTH

Manish

New Member

FAC not working with 3905

Is this Fixed in latest Firmware ? 9.4 ?

Regds

$

Cisco Employee

FAC not working with 3905

New Member

FAC not working with 3905

Hi Manish

Thanks for the info,

Regds

$

379
Views
5
Helpful
5
Replies