Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

FAC UC500

Hi, I configure the UC500 whit the following commands to enable the Force Authorizatin Code:

application

service clid_authen_collect

param uid-len 3

param pin-len 3

aaa new-model

aaa authentication login h323 local

aaa authorization exec h323 local

aaa authorization network h323 local

username 452 password 452

username 452 autocommand exit

dial-peer cor custom

name internal

name local

name international

name international-fac

dial-peer cor list call-international-fac

member international-fac

dial-peer cor list user-international-fac

member internal

member local

member international-fac

dial-peer voice 10 pots

service clid_authen_collect

tone ringback alert-no-PI

destination-pattern 9[1-9]T

direct-inward-dial

corlist incoming call-international-fac

corrlist outgoing call-international-fac

ephone-dn 20 dual-line

corlist incoming user-international-fac

dir flash:

enter_account.au

enter_pin.au

But the call is established whitout enter the username and password. The call is established without problem. but the prompt is not heard. What is the error o missing in the configuration?

Thanks

Source: https://www.myciscocommunity.com/docs/DOC-1400%3Bjsessionid=E5DC5DD8503D5F829C71F08FFF02C2B8

1 REPLY
Hall of Fame Super Gold

Re: FAC UC500

Hi,

note they use a "loopback" voip DP to trigger the service. You instead only have the pots DP, that is not enough.

All in all is quite complicated, it would be easier to use after-hours and PIN login, or simply a secret prefix that you configure as destination pattern for international calls.

409
Views
0
Helpful
1
Replies
CreatePlease to create content