Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

factory reset cucm 8

Hi everyone,

lateley i have installed callmanager version 8 based.

I was wondering if its possible to put everyhing in default, so i mean without re-installing cucm again.

Right nowe i have a callmanager with routepatterns configured, also CSS, partitions, h323 gateways, mgcp sip.

I would like to have the whole callmanager empty , so its just like i installed callmanager from scratch.

Is there a quick way to do that? without installing callmanager over again.

This if for lab purposes

  • IP Telephony
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

factory reset cucm 8

No, there is no way to erase all configuration without doing it manually. One option for the future would be to take a backup after initial install and keep it should you need to restore back to blank config.

HTH,

Chris

2 REPLIES
Hall of Fame Super Silver

factory reset cucm 8

No, there is no way to erase all configuration without doing it manually. One option for the future would be to take a backup after initial install and keep it should you need to restore back to blank config.

HTH,

Chris

New Member

factory reset cucm 8

Chris thanks for your reply.

I will keep this in mind for the next time!

169
Views
0
Helpful
2
Replies