Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Fail to Chage the Interdigit Timeout Value in Cisco Gateway

Hello Everybody

 

I have this call flow:

 

PSTN (FXO) --> TCL File | Gw (H323) --> CUCM --> IP Phone

 

I have next Dial-peer in Gateway whith 9T pattern:

dial-peer voice 101 voip
 translation-profile outgoing test
 destination-pattern .T
 session target ipv4:10.1.1.12
 dtmf-relay h245-alphanumeric
 no vad

 

Please your help to reduce the interdigit timeout value because 10 seconds are too long.

I have tried this:

 

In the voice port:

voice-port 0/1/0
 timeouts interdigit 2

 

Under Telephony Service:

telephony-service
 timeouts interdigit 2

 

Under H323:

h323
  h225 timeout t302 2

 

No option worked. Some suggestion??

Thanks in advance!

 

3 REPLIES
New Member

Hello there. I just ran into

Hello there. I just ran into the same issue on 3945E running 154-3.M4 code. I have opened a Cisco case, but not getting anywhere with it yet.

Hi.Are you also using a TCL

Hi.

Are you also using a TCL script?

 

please post your config and your call flow

 

Thanks

 

Regards

 

 

Carlo

 

Please rate all helpful posts "The more you help the more you learn"
New Member

Thank you for your note. I

Thank you for your note. I got my issue resolved. There were not a TCL script involved. I was testing a SRST setup and was trying to change interdigit timeout with  timeouts interdigit command under voice-port with no affect. The actual command that changes it for eFXS ports (phones registered to SRST gateway) is timeouts interdigit  command under call-manager-fallback.

 

63
Views
0
Helpful
3
Replies
CreatePlease to create content