Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Failover Firstnode to Subsequent node Timer setting

Hi

I have a cluster with a Firstnode and a Subsequentnode. The sw version is 6.1 When I test the failover ( disconnect the UTP cable ) the phones switches over to the Subsequentnode and that works fine. But it took about 20 seconds for the failover. Is it possible to change the timer ?

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: Failover Firstnode to Subsequent node Timer setting

Nop...

I would say that is expected, since TCP sessions are timing out and thats part of TCP protocol.

If You stop CCM service failover should happen inmediatly since we are sending TCP RST

1 REPLY
Green

Re: Failover Firstnode to Subsequent node Timer setting

Nop...

I would say that is expected, since TCP sessions are timing out and thats part of TCP protocol.

If You stop CCM service failover should happen inmediatly since we are sending TCP RST

90
Views
5
Helpful
1
Replies