Can you help me with my problem? I have setup a DN that when called from outside the office, the call will be forwarded to Cisco MeetingPlace via on-net and when the WAN is down, the call will failover to PSTN (off-net). When I called the DN from outside but within the Philippines, on-net and off-net is working perfectly. However, if a colleague from abroad dials the same number and the WAN is down, the call doesn't failover to PSTN.
I'm using CM 5.1(3c) and using a 3845 GW for inbound and another 3845 GW for outbound.
The part that doesn't work is, when someone outside the Philippines dial a DID (e.g. 63 2 999-1234) and WAN link is down. The call should failover to my outbound GW and dials another number but isn't. I just hear a beep sound.
If the call is from within the Philippines even the WAN is down, failover is working
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.