Fast busy signal with incoming calls and unable to connect to VM
We are using CISCO 2821. The system started to have problem connecting to voice mailbox (when dialing internally to the VM extension) and it used to take a reboot to bring it back. Now it will not connect to voice mail (gets fast busy signal), plus incoming calls get a fast busy signal after the first ring tone. To make it worse, the Call Manager Express web page does not load. Does anyone have any idea how to solve the problem? Thanks!
Re: Fast busy signal with incoming calls and unable to connect t
I have some of the information:
- The CPU is running normally. - VM Software - Cisco Unity Express Version 2.3 - Incoming calls to the main DID number is getting fast busy signal that the caller is hearing. When it worked normally, incoming calls to the main number would be connected to the Auto Attendant, where caller would hear voice greetings and could dial an extension number. There is no internal phones assigned the main number. Incoming calls to other DID numbers (direct numbers) are coming through.
- I have not done any debug before. I would appreciate it if you could provide some guidance on debug isdn q931 and voice ccapi inout.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...