Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Fast busy tone after hangup

Called party hears a fast-busy tone when the calling party hangs up.

I have checked and there are no timeout commands configured for disconnect or release.

Dial-peer configuration has the following:

dial-peer voice 1 pots

description Link to Telkom SDH E1 0/0.3/3/1 ### outgoing calls ###

destination-pattern 8T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

progress_ind disconnect enable 8

incoming called-number .

clid restrict

direct-inward-dial

port 0/0.3/3/1:D

!

Any ideas how to stop this tone so that when the calling party hangs up, instead of fast busy tone, the call disconnects and releases?

4 REPLIES
Hall of Fame Super Gold

Re: Fast busy tone after hangup

Who is the calling party ?

Unrelated, you probably do not need none of the progress_ind commands.

New Member

Re: Fast busy tone after hangup

I think it is a problem with the call not being released after disconnect is received...

Hall of Fame Super Gold

Re: Fast busy tone after hangup

Sorry, you're not explaining yourself.

Who is the calling party ?

Who hears disconnect tone ?

Why you say the call is not released ?

New Member

Re: Fast busy tone after hangup

Calling party, is the person dialling in from the PSTN, called party is the call centre agent, the called partyheres the tone after the calling party hangs up. Turns out it was the command: voice call discipi off, i removed it and it removed the tone and the call disconnects now when either party hang up/goes on hook again.

Will make note of this for future.

361
Views
3
Helpful
4
Replies
CreatePlease to create content