We are getting a busy signal when dialing from an IP phone to a FXS port. The extension numbers 80XX are in the same calling search space, does anyone have any ideas on what to research? We have changed the CSS classification between the FXS ports to see if that made a change...fast busy. Could it be the router causing the busy signal. TIA - Thomas NH
Its MGCP and all extension are in the same unique partition. I'll check the dial-peers on the router again. What I do not understand is, it's an intermittent busy on FXS ports? If I dial from an IP phone to an IP phone in the same DID range (partition)the phone rings OK, but if I dial a FXS port in the same DID range (partition) I get busy tone. I have done 10 Nortel to VoIP conversion this year and have never seen this problem ever. We are running CUCM 6.12 and have several sites out there with almost same setup, but do not have these types of problems. I wonder if it has anything to do with the OSPF? I am open for anything - Thanks Thomas NH
That issue is related to CLID on outbound calls, we are OK there. We are passing the External Phone Number Mask with no problems on the PRI T1s. This problem is within the partition itself and is a major problem. Mainly my project is in jeopardy from being cut over. Any other ideas...TIA-ThomasNH
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.