Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Fast busy when dialing "proxy" 911

New install of CER1.3 I am using 6666 as a "proxy" for 911 while I do a test configuration. I have a CTI Route point with a DN of 6666 controlled by the CER. I have also configured a test ERL with an ELIN. The pattern is modelled after the install guide. 10.6666. I added a transform mask of 4345 to send any calls to my POTS desk phone to execute the test. If I dial 10.6666 from an IP phone, my POTS desk phone rings as expected. However, if I dial 6666 from my IP phone, I get fast busy and no activity on the web alert page of the CER.

1 REPLY
Green

Re: Fast busy when dialing "proxy" 911

Use the Call history to see if the call is hitting CER or is being blocked in CCM

Double check the config guide

http://www.cisco.com/univercd/cc/td/doc/product/voice/respond/res13/admin13/e911c42.htm

129
Views
0
Helpful
1
Replies