Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Fast Busy when sending calls over Intercluster Trunk to PSTN

I have CCM6.1(2) setup in a lab w/ a Intercluster trunk connecting to our Production 4.2(3)environment. I can place calls back and forth between the two clusters over the ICT so the trunk is working, but I cannot place calls from the lab to PSTN via the ICT. I see the calls on the H323 gateway, but I get a fast busy on the phone. A debug on the H323 Gateway shows this:

Cause i = 0x80AC - Requested circuit/channel not available

Any ideas? Thanks.

4 REPLIES
Hall of Fame Super Silver

Re: Fast Busy when sending calls over Intercluster Trunk to PSTN

Can you post the entire "debug isdn q931".

Chris

Community Member

Re: Fast Busy when sending calls over Intercluster Trunk to PSTN

Thanks Chris for taking a look.

Hall of Fame Super Silver

Re: Fast Busy when sending calls over Intercluster Trunk to PSTN

You are sending 10 digits "2027115911" is this what you want? Is 10 digit dialing allowed in this area code? What happens when you send the call as 7 or 11 digits?

Chris

Community Member

Re: Fast Busy when sending calls over Intercluster Trunk to PSTN

Yes. In the DC Area, you can send out 7, 10 & 11 Digits. I have dial-peers setup on the voice gateway for all 3. Sening out 7 digits gets the same result.

275
Views
0
Helpful
4
Replies
CreatePlease to create content