Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Fax from ATA to ATA using H323

Hello!

I have an H323 gateway and want to set it up where I can fax from one fax machine connected to an ATA to another fax machine connected to a separate ATA. Can this be done and if so, what do I need to add or remove from my configuration? I have attached the configuration of the ATAs. I know its missing from below but I do have the h323 interface configuration on the gateway.

voice service voip

fax protocol t38 ls-redundancy 2 hs-redundancy 0 fallback none

h323

no h225 timeout keepalive

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8

!

!

!

voice class h323 1

h225 timeout tcp establish 3

!

!

application

global

service alternate default

!

!

!

dial-peer voice 10000 voip

destination-pattern 9295

progress_ind setup enable 3

modem passthrough nse codec g711ulaw

voice-class codec 1

session target ipv4:172.24.86.21

incoming called-number 9295

dtmf-relay h245-alphanumeric

fax rate disable

no vad

!

dial-peer voice 15172 voip

description ** Inbound DIDs to ATA **

destination-pattern 5172

progress_ind setup enable 3

modem passthrough nse codec g711ulaw

session target ipv4:172.24.86.27

incoming called-number 5172

dtmf-relay h245-alphanumeric

fax rate disable

no vad

!

!

no dial-peer outbound status-check pots

gateway

timer receive-rtp 1200

!

!

  • IP Telephony
2 REPLIES
Silver

Re: Fax from ATA to ATA using H323

Cisco Employee

Re: Fax from ATA to ATA using H323

I checked your configurations and they are fine. Assuming that you have call routing configured correctly and you match the correct dial-peers on the H.323 gateway you should be able to send and receive fax calls between these three devices.

Regards,

David

346
Views
0
Helpful
2
Replies