I have connected fax, through SCCP - ATA and VG202 but observing problem. I have external BRI lines. When incommuing call comes for the fax only at the begging fax signal is heard (about 1 second) then it stops. I have configured the voice gateway as h323 or sip but the same behaviour occurs. The vad is disabled and there is network clock select and participate for the BRI interfaces. The only codec used is G.711ulaw.
Any suggestions for the reason of this behaviour will be greatly appreciated.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...