All faxes that are coming from the 1800 number are getting printed instead of going through the fax to email process. The config seems to be correct... Can think what is missing....
fax receive called-subscriber $d$ fax interface-type fax-mail mta send server xxx.xxx.xxx.xxx port 25 mta send subject "New FAX" mta send postmaster firstname.lastname@example.org mta send mail-from hostname cme.com.com mta send mail-from username FAX ! application service fax_onramp flash:app_faxmail_onramp.188.8.131.52.tcl service onramp flash:app_faxmail_onramp.184.108.40.206.tcl
dial-peer voice 3701 pots service fax_onramp incoming called-number xxxxxxxx direct-inward-dial port 0/0/0:15 ! dial-peer voice 3702 mmoip service fax_on_vfc_onramp_app out-bound destination-pattern 370 information-type fax session target mailto:email@example.com
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.