I'm trying to setup the faxfinder ff240-ip fax appliance with a ISR 3925 router running call manager express 8.6. The router has a connection to the PSTN using a T1 PRI. The appliance doesn't have a analog port; only RJ45 ethernet. I know it will use SIP for the call control protocol but I'm not sure how to configure CME to be able to route incoming calls to it from the desginated fax numbers. I assume it would require pots and voip dial peers. Has anyone setup this type of fax server or can offer some advice for the CME side of the configuration?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...